What we build — in detail.

Our specialty: parts that can no longer be bought. The original manufacturer is gone, the tooling is scrapped, or the minimum order is absurd for the two pieces you need. We reproduce geometry directly from a surviving physical sample — no drawings required.

• Discontinued appliance, equipment, and machine components
• Marine hardware — UV-degraded plastics reprinted in UV-stable ASA
• Farm and shop equipment parts the dealer stopped stocking
• Legacy housings, brackets, knobs, and interior fittings

Production aids for shops that make things — printed in tough, dimensionally stable materials at a fraction of machined cost, and iterated in days when the line changes.

• Assembly jigs and alignment fixtures
• Check gauges and inspection aids
• Soft jaws, workholding, and robot end-of-arm tooling
• Line-side organizers and shadow boards

From sketch to functional prototype with revision cycles measured in days, not weeks — and straight answers, including telling you when 3D printing is the wrong tool for the job.

• CAD design and design-for-printing review
• Iterative design-and-build cycles
• Functional, load-bearing prototypes in engineering materials
• STEP / STL files delivered with your job — the CAD is yours

We digitize the physical part with structured-light 3D scanning and rebuild it as clean, editable CAD. You receive both the printed part and the model — so the next one is a reorder, not a project.

• 3D scanning and CAD reconstruction from the sample
• Broken parts rebuilt whole — and improved where the original failed
• Material upgrades: stronger, UV-stable, or flexible reprints
• Customer owns the delivered CAD model

Production quantities while you wait on hard tooling — or instead of it. No molds, no tooling charges, and revisions between batches whenever you need them.

• Bridge runs while injection tooling is cut
• Short-run end-use parts in engineering polymers
• Consistent, calibrated repeat orders from stored CAD
• Per-part pricing that scales with quantity

Rock 3D Solutions is a service-disabled-veteran-owned small business one hour from the Detroit supplier corridor at the Blue Water Bridge gateway. Obsolete-part (DMSMS) reproduction is what the shop is built around: scan-to-CAD-to-part, lot sizes of one, fast simple invoicing.

• Micro-purchase friendly — right-sized for GPC/credit-card orders under $15,000
• Accepts GPC / credit card / PO / ACH
• Michigan SDVOB — eligible for the up-to-10% state pricing preference
• Single point of contact — owner-operated